New issue

Have a question about this project? Sign up for a free GitHub account to open an issue and contact its maintainers and the community.

Sign up for GitHub

By clicking “Sign up for GitHub”, you agree to our terms of service and privacy statement. We’ll occasionally send you account related emails.

Already on GitHub? Sign in to your account

Jump to bottom

Clarify CPAP docs #88

Open

Tracked by

HumbleDeer opened this issue Oct 2, 2023 · 0 comments

Open

Tracked by

Clarify CPAP docs #88

HumbleDeer opened this issue Oct 2, 2023 · 0 comments

Labels

Vz235 Mellow Vz330 Mellow

Milestone

Issues noted duri...

Contributor

HumbleDeer commented Oct 2, 2023 •

edited

Loading

CPAP / Umbilical Cord

Noted during stream: https://www.youtube.com/watch?v=9ZZNjZha22Q

Routing

How does the umbilical cord route?

Looks like it's along the cable guide
then on the back side of the back panel outside of the printer, in to the electronics box)
Does this use a printed part?
Looks like the top hat should have a cutout for the wiring loom to pass through; is the wiring loom protected?

How does the CPAP tube route?

Ties to the cable guide
Passes into the enclosure in front of the rear top extrusion
Goes into the round hole under the extrusion, at an angle
- Does this use some printed part to protect the tube?

Specifically for Mellow Vz330/Vz235: Perhaps the CPAP printed part at the print head could have a threaded section to thread the CPAP tube on to?

Toolhead wiring

Does the umbilical cord get a protective sleeve, liek a braided sleeve?
How does one attach the wires to the CPAP tube? Zip ties, or velcro ties?
The CPAP tube is very fragile!

HumbleDeer mentioned this issue

Noted during Nero3D Stream part 6 #55

Open

7 tasks

HumbleDeer added this to the Issues noted during Nero3D stream milestone

HumbleDeer added Vz330 Mellow Vz235 Mellow labels

Sign up for free to join this conversation on GitHub. Already have an account? Sign in to comment