manipulator not registered #456
-
|
Hi, I can successfully run the ephys-link, and also connect it with the pinpoint, but the pinpoint use a 4 axes data, our sensapex setup only with the old 3 axes manipulator, how can i fix the error? |
Beta Was this translation helpful? Give feedback.
Replies: 2 comments 1 reply
-
|
Hi thanks for looking into using ephys-link and Pinpoint! Unfortunately we don't currently support the Sensapex uMP-3 manipulator with just the three axes. We are working on getting our hands on one for testing so that we can add them to the system! We'll update this issue when we get these working. |
Beta Was this translation helpful? Give feedback.
-
|
Development will be tied to this issue: #458 |
Beta Was this translation helpful? Give feedback.
-
|
To update, the latest version of Ephys Link supports uMp-3 manipulators. You can launch Ephys Link with uMp-3 support with |
Beta Was this translation helpful? Give feedback.
Hi thanks for looking into using ephys-link and Pinpoint! Unfortunately we don't currently support the Sensapex uMP-3 manipulator with just the three axes.
We are working on getting our hands on one for testing so that we can add them to the system! We'll update this issue when we get these working.