Extruders not heating when starting print

[tigollbitties24]

So far everything up until this point has been great and you did a great job with all of this. However I'm just a bit confused as to how I'm supposed to select the extruder that I want to use, and have it heat up to the temp that I set, as well as display the temp that the extruder needs to reach.

For example when I start a print it will usually look something like this:
Heating:■■■
R Extruder: 24/220ºC
L Extruder: 24C
Platform: 32/100ºC

But when I started the print using Cura it looked like this:
Heating:■■■
R Extruder: 24C
L Extruder: 24C
Platform: 32/100ºC

If you know what's going on with this, or how I can fix it that would be great!
Lastly I don't have discord installed, but if you'd prefer discord then I'm more than happy to install it lol

Thank you!

[Toylerrr]

Should heat the bed up first then it should heat the nozzle.

…

On Sat, Oct 30, 2021, 7:44 PM tigollbitties24 ***@***.***> wrote: So far everything up until this point has been great and you did a great job with all of this. However I'm just a bit confused as to how I'm supposed to select the extruder that I want to use, and have it heat up to the temp that I set, as well as display the temp that the extruder needs to reach. For example when I start a print it will usually look something like this: Heating:■■■ R Extruder: 24/220ºC L Extruder: 24C Platform: 32/100ºC But when I started the print using Cura it looked like this: Heating:■■■ R Extruder: 24C L Extruder: 24C Platform: 32/100ºC If you know what's going on with this, or how I can fix it that would be great! Lastly I don't have discord installed, but if you'd prefer discord then I'm more than happy to install it lol Thank you! — You are receiving this because you are subscribed to this thread. Reply to this email directly, view it on GitHub <#10>, or unsubscribe <https://github.com/notifications/unsubscribe-auth/ABBSOBQFVKLSPEVMCKCAVB3UJSURZANCNFSM5HBYCI5A> .