Home

Welcome to the Solidsense-Connect wiki!

# Updating a SolidSense Board

This is an example how to updating a SolidSense N6 board.

Download the last N6 image mender on your board and install it following theses commands:

# mender install https://images.solidsense.io/SolidSense/mender/SolidRun-signed/2.0.2/n6gsdl-core-image-minimal-Solidsense-2.0.2-2023010500.mender
# mender commit
# /opt/scripts/restart --wipe

After boot, Kura will be available after 4 minutes. You can check your configuration by taping https://serial_number_of_your_gateway or https://ip_address_board on your navigator.

If you dont able to load Kura from browser

# /opt/scripts/restart --config

Wait for reboot, kura will be available after 4 minutes.