Skip to content

Software Setup

Chitoku YATO edited this page Dec 6, 2023 · 27 revisions

This page is deprecated.

Please check out the new instructions on jetbot.org

This page details the software setup required to run JetBot.

Step 1 - Flash JetBot image onto SD card

  1. Download the expandable JetBot SD card image jetbot_image_v0p4p0.zip

    The above image is based on JetPack 4.3. The previous image based on JetPack 4.2 may be found here: jetbot_image_v0p3p2.zip.

  2. Insert an SD card into your desktop machine

  3. Using Etcher, select the jetbot_image_v0p4p0.zip image and flash it onto the SD card

  4. Remove the SD card from your desktop machine

Step 2 - Boot Jetson Nano

  1. Insert the SD card into your Jetson Nano (the micro SD card slot is located under the module)

  2. Connect the monitor, keyboard, and mouse to the Nano

  3. Power on the Jetson Nano by connecting the micro USB charger to the micro USB port

    Important! We recommend first booting the Jetson Nano once without the piOLED / motor driver connected. This way you can check to make sure the system boots properly from the SD card image without worrying about hardware issues. After you've verified that it boots, reconnect the piOLED, double check your wiring, and boot again.

Step 3 - Connect JetBot to WiFi

  1. Log in using the user jetbot and password jetbot

  2. Connect to a WiFi network using the Ubuntu desktop GUI

Your Jetson Nano should now automatically connect to the WiFi at boot and display it's IP address on the piOLED display.

Step 4 - Connect to JetBot from web browser

After your robot is connected to WiFi, you can connect to the robot from a web browser by performing the following steps

  1. Shutdown JetBot using the Ubuntu GUI

  2. Unplug your HDMI monitor, USB keyboard, mouse and power supply from Jetson Nano

  3. Power the JetBot from the USB battery pack by plugging in the micro-USB cable

  4. Wait a bit for JetBot to boot

  5. Check the IP address of your robot on the piOLED display screen. Enter this in place of <jetbot_ip_address> in the next command

  6. Navigate to http://<jetbot_ip_address>:8888 from your desktop's web browser

You shouldn't need to connect your robot to a monitor past this step!

Step 5 - Install latest software (optional)

The JetBot GitHub repository may contain software that is newer than that pre-installed on the SD card image. To install the latest software:

  1. If you haven't already, connect to your robot by going to http://<jetbot_ip_address>:8888

  2. Click the + icon to open the Jupyter Lab launcher

  3. Launch a new terminal

  4. Get and install the latest JetBot repository from GitHub by entering the following commands

    git clone https://github.com/NVIDIA-AI-IOT/jetbot
    cd jetbot
    sudo python3 setup.py install
  5. Replace the old notebooks with the new notebooks by entering

    sudo apt-get install rsync
    rsync jetbot/notebooks ~/Notebooks

Step 6 - Configure power mode

To ensure that the Jetson Nano doesn't draw more current than the battery pack can supply, place the Jetson Nano in 5W mode by calling the following command

  1. If you haven't already, connect to your robot by going to http://<jetbot_ip_address>:8888

  2. Click the + icon to open the Jupyter Lab launcher

  3. Launch a new terminal

  4. Select 5W power mode

    sudo nvpmodel -m1
  5. Verify the Jetson Nano is in 5W power mode

    sudo nvpmodel -q

Next

Follow the examples.

Analytics

Clone this wiki locally