Gerber file

[Forza400]

Hello,

Im in the proces of building this awesome mod for my G29 pedals. I was wondering if you had the gerber file so i can have PCB way make this custom PCB. This way i don't have to make it myself trough the proces of etching.

[GeekyDeaks]

I have some spare if you want me to post you a couple

[Forza400]

Man that would be more then i could hope for. If you can estimate the cost of sending it to Belgium i can pay you with paypal for your pcb and postage fees?

[GeekyDeaks]

Ah, if you are keen enough to tackle this then posting a few PCBs is the least I can do to help :D. Just send me your address to [email protected] and I'll sort it out early next week. I suspect they will fit in a standard letter anyway.

[Forza400]

Sent you an email. Thanks allot for your help. Send it whenever you have spare time, im not in a hurry as im still waiting for some of the electrinic parts 👍

[Forza400]

Hi, all the parts have arived and i'm 3d printing the rest. While printing i was looking at the diagram and reading trough all the comments. I saw you mention putting a cap on C1. What do you mean with a cap? If i understand everything correctly when i want to build a single loadcel no clutch type of pcb i need to:
-Leave R_REF empty, but bridge the middle and the right hand pin.
-Connect the largest of the 1k resistors to R1 and the other one to R2.
-Connect the 10ohm trimpot to R_BAL1
-Connect the 1K ohm trimpot to R_GAIN
-Put some ?magical 'cap'? on C1
Sorry for these novice questions but i wanna make sure i don't mess up and get frustrated :)