Build
This Tutorial uses the original PCB from Blueforcer.
if you want to build it your own way you can use the schematic.
Download and print the case in your favorite color.
(Button 1 is next to the OLED)
- OLED - 8cm
- Button 1 - 11cm
- Button 2 - 13cm
- Button 3 - 15cm
- Button 4 - 17cm
- Button 5 - 19cm
- Button 6 - 21cm
- Button 7 - 23cm
- Button 8 - 25cm
OLED:
| OLED | COLOR | PCB |
|---|---|---|
| SCL | black | SCL |
| SDA | red | SDA |
| VCC | white | VCC |
| GND | yellow | GND |
BUTTONS:
| BUTTON | COLOR | PCB |
|---|---|---|
| COM | yellow | B |
| NO | white | B |
| V+ | red | L+ |
| GND | black | L- |
Insert the first button and tighten the locknut by hand. Then you insert the second button, from here you have to put on the locknut and turn the button instead of the nut, otherwise there is not enough space for finger and locknut. Continue in this way with all further buttons.
You can use the OLED clamp to screw the display into the housing, You can also use hotglue if you do not have suitable screws.
(Sectional view)
The cables can now be connected to the PCB and inserted into the housing.
Now solder the cables to the corresponding buttons one after the other. Please check the pin assignment of your buttons carefully! Not all buttons are the same! If you are not sure, test Smartpusher with one button first.
If everthing is connected, screw the back part to the housing
Congratulations, your smartpusher is ready!