Replies: 1 comment 9 replies
-
how us the |
Beta Was this translation helpful? Give feedback.
9 replies
Sign up for free
to join this conversation on GitHub.
Already have an account?
Sign in to comment
-
Hi folks,
This documents my progress on ViewQwest SG. This doesn't work yet, but I figured that it could still be helpful to someone.
Hardware
ISP Hardware: Fiberhome HG6240A
Replacement Hardware: DFP-34X-2C2, stock firmware (V1.0-220923) transparent mode, connected through a gigabit media converter, which is also connected to an x86 OpenWrt PC.
Status
l2-table get entry address valid
automatically has an entry for Vid 931, matches shown vlan on fiberhome ont admin page... butomcicli mib get 84
shows VID 0 for all entries. hmmmConfiguration
OpenWrt, eth1 (GbE) connected to media converter:
Expected result
OpenWrt should have automatically picked up an address over DHCP and stuff should then magically work.
Original ONT configuration
Extra notes:
DFP-34X-2C2 does not appear to work on the Mellanox ConnectX-3.
The stick seems to be stuck in configuration, every ~234 seconds, the device pops up for exactly 20 seconds, and then goes back down again.
FWIW, the CX3 does not claim to support 2.5g anywhere.
Beta Was this translation helpful? Give feedback.
All reactions